Position the valve body 32 inches from the floor of the tub basin. The shower arm should be placed 78 inches above the floor of the tub basin (recommended installation of the shower arm is with a flanged elbow fitting – not included – and attached to a wood brace).

I show you how I install a shower valve purchased from Lowes by Moen. we use PEX for the plumbing. it's detailed so the DIYer can follow along and get it don...

After installing and connecting your new faucet, install shower arm but not showerhead before flushing. 2. Turn the valve on in the full cold position (handle pointing to the right) and turn on the cold supply for 15 seconds.

How-To Videos for kitchen & bath faucets, tub & shower fixtures, faucet cartridges, garbage disposals, and other Moen products.

This video show how to install a Moen posi temp valve. This is a Moen 1/2 Inch PEX Posi-Temp Pressure Balancing Rough-In Valve. I will solder 2 fittings onto the moen posi temp valve for the...

Dec 15, 2021 · Before You Install. Before installing the U by Moen Smart Shower system, it’s important to consider a few key factors such as the number of shower outlets the homeowner intends to use in the shower, valve placement, location of a …

This video shares a Moen shower valve installation inside a tub shower. There are tips for soldering copper to the valve, using PEX, and more. For more home ...

Jan 19, 2022 · For more information on the 1222 Cartridge Installation, see video, Installing a 1222 Cartridge. 1. Remove the retainer clip by using needle nose pliers to slide the retainer clip up (#3) and out from the top of the valve body (#5). Be careful not to drop the retainer clip (#3) behind the wall.

Jun 23, 2021 · This article will give step-by-step instructions on how to replace a 1225 flow cartridge in a single handle Standard valve shower. The water supply shut off valves must be turned off- see article How to Turn Off the Water Supply to the Faucet. The following instructions assume the handle and associated handle pieces have been removed.

install handle. Turn on water, pull up on tub spout diverter knob and flush the shower riser for 15 seconds. Install showerhead and check system for leaks. If there are no leaks, turn OFF water and remove handle and limit stop. Install escutcheon plate with two screws provided. Mount with the escutcheon notch UP.