The most accurate differential identification is provided by the bottom line of the tag number or axle tube stamp. Differential tags can easily be used to identify Dana and Ford differentials.

Aug 28, 2024 · 10 Tips on How to Identify a Dana 44 Tip 1: Bolt Pattern. The most important indicator of a Dana 44 is its bolt pattern. This axle typically has a 6-bolt circular pattern on the wheel hub, with each bolt spaced equally apart. If you see this pattern, there’s a high chance it’s a Dana 44. Tip 2: Cover Shape

Mar 23, 2020 · To figure out exactly what axle you have, you can look for the Dana stamped bill of materials number. This stamped number can usually be found on the righthand side or on the longer...

Dana design axles from 1977 thru 1980. Positive identification of the Corporation (Chevrolet) axle versus the Dana axle is necessary for proper selection and ordering of service replacement parts.

Identifying these axles can be done visually (by professionals) or via the use of tags. This article will explain how to identify your vehicle’s axle code and provide you with a detailed chart of front and rear axle codes in popular Dana trucks and cars.

Compare the gasket shape to Nationwide Parts' Axle Identification Chart to determine the Dana model number. Dana models 25, 27, 30, 60, 70 and 80 have identical gasket shapes and bolt counts and therefore must be identified by locating the identification tag.

The chart below may be used as a guide to identifying various Dana front and rear axles that have been used in Jeep, GM, Dodge, and Ford applications through the years. Only factory equipped full floating axle for Jeep vehicles. Up to 2,770 lbs GAWR. Up …

This guide can be used to help identify your rear axle make/model. This information should help you locate the Auburn Gear differential model appropriate for your vehicle.

Dana axles are very easy to identify and their numbering system is consistent irregardless of the vehicle they came in. The axle model number is cast in to the housing (30, 44, 60) either on the right (facing the axle cover) lower web at the point where the axle tube is pressed in to the center section or in the nose of the housing near the ...

Dana 41 rear axles were used by Jeep from 1946 to 1950. The Jeep Dana 44 Rear axle with tapered axle shafts was used from mid-1950 to 1971. Jeep phased in Dana 44 axles with flanged axle shafts in the 1969 model year although the tapered shaft version was used for some applications until 1971.