Building A Pocket Sized Arduino Oscilloscope. 10 Comments . by: Tom Nardi. September ... It took some experimentation to find the proper prescaler value for the Atmega’s 16MHz clock, ...

45 thoughts on “ Arduino Oscilloscope At Five Megasamples Per Second ... No synchronizing of the clock, thus the glitches. However if I tapped into the Arduino clock it might just work ...

Sean took an antique clock an removed the mechanisim, and then replaced it with an Arduino, that is programmed to check the weather on the Environment Canada website every fifteen minutes.

Makers, hobbyists and developers that are looking for an ultra Low cost 4 Channel 300KS/s Oscilloscope that is both Arduino compatible and been specifically designed to complement the DIY test bench.

The AD9851 DDS board is shown connected to an Arduino in Figure 2. The Arduino is used to set the DDS output frequency. A DC block, the Picotest J2130A (shown in the figure, www.picotest.com) or the ...

Lets say you upload and set the time at 2pm. Then u still keep that particular line of code. Then you power on the arduino again at 4pm. But the arduino start the code by adjusting the time to 2pm ...

To make your own Arduino based oscilloscope, follow these four steps.Your board will be able to use up to four input channels at frequencies up to 7 kHz and as many as seven input channels at 4 kHz.

You have a timer and clock in just about every single device out there these days, but if you want to build you own, Instructables user GeraldF6 shows you how to do so with a Arduino.

Just when you thought you’ve seen every strange variation of clock there is to see, we find one based on an Arduino that tracks the phases of the moon. The “Lunar Phase Clock” is a project ...